How to use IPMI commands to get/control system status on R1520G6/R2520G6
Question
How
to use IPMI commands to get/control system status on R1520G6/R2520G6
Answer
This document explains how to use IPMI commands via two methods to get/control
system status.
IPMI (Local): Executed locally on R1520G6/R2520G6 Linux O/S.
IPMI client console (OOB): Run from a remote system using network access to the
BMC (LAN interface)
IPMI client console: Run ipmitool.exe in CMD or PowerShell as an administrator.
Please refer to the details as attached.
Related Articles
How to use ipmi command to set next boot as PXE boot
If customer needs to use ipmi command to set system next boot as PXE boot. Then customer can use below command to let their system boot to PXE mode at next power-on. ipmi command: #ipmitool chassis bootdev pxe (for Legacy mode) #ipmitool chassis ...Ipmi command "ipmitool sel list " doesn't show sel log on D50DNP system.
Fail symptom : No message print after perform "ipmi sel list " , only show "sel has no entries" Root cuase : OpenBMC does not have the static SDR design like legacy BMC, so when adding a SEL entry via a raw command, the BMC will attempt to map it ...How to use IPMITOOL to modify BMC FRU file
How to use IPMITOOL to modify BMC FRU fileMitac EGS Platform Get BSOD Issue while installing WS2019 OS
Mitac EGS Platform Get BSOD Issue while installing WS2019 OSIssue with H100 / L40 / L40s not detected in the system
If the Nvidia H100 / L40 / L40s cards are not detected in your system please check the power connection to the power supply has the correct sense pins to card. Table 7 lists the power level options identifiable by the PCIe 16-pin power connecter per ...